Abicor Binzel FEC W3, Инструкция по эксплуатации

Страница: 48 / 132

EN - 16
BAL.0675.0 • 2019-09-16
6 Putting into operation FEC W3
6.3 Current clamp (optional)
If welding conditions are not favourable, a current clamp instead of an earth cable may be used. This is connected to the
FEC W3 via the 4-pole plug and routed above the earth cable and cable assembly as required. When the welding process
starts, the FEC W3 receives a signal and starts the extraction process.
1 Connect the current clamp plug to the current clamp socket (4) .
2 Route the current clamp above the earth cable or the cable assembly.
3 Press the A/Auto (1) button on the control panel.
The extraction process starts as soon as you start the welding process.
1 A/Auto button 2 Motor protective switch 3 Power cable connector 4 Socket for current clamp (optional)
Fig. 7 Current clamp
1 Current clamp 2 Red dot 3 Cable assembly
Fig. 8 Current clamp above cable assembly
NOTICE
• It is imperative that you ensure that the red dot on the current clamp is always pointing in the direction of the current
flow.
1
2
3
4
1 2
3