Abicor Binzel ABI-CAR E-1200, Инструкция по эксплуатации

Страница: 52 / 68

EN - 20
BAL.0647.0 • 2018-08-24
7 Operation ABI-CAR E-1200 / E-1200-O
Fine adjustment of the cross slide
1 Use the adjusting screw (2) on the top cross slide to adjust the vertical direction; use the adjusting screw (1) on the side
cross slide to adjust the horizontal direction.
7 Operation
1 Adjusting screw for horizontal position 2 Adjusting screw for vertical position
Fig. 14 Fine adjustment of the cross slide when mounting the welding torch
1 2
DANGER
Shortness of breath and poisoning caused by inhaling phosgene gas
When welding workpieces that have been degreased with chlorinated solvents, phosgene gas is formed.
• Do not inhale smoke and vapors.
• Ensure a sufficient supply of fresh air.
• Rinse workpieces with clean water prior to welding.
• Do not place degreasing baths containing chlorine in the vicinity of the welding area.
DANGER
Risk of burns
During welding, sparks, glowing workpieces or hot slag can produce flames.
• Check the work area for flashpoints.
• Provide appropriate fire extinguishing equipment in the workplace.
• Allow workpieces to cool down after welding.
• Prior to commencing welding work, properly fasten the ground clamp to the workpiece or welding table.
• Wear your personal protective equipment.
WARNING
Arc eye
The arc produced by welding can damage the eyes.
• Wear protective clothing and eye protection.