1YSA160045-EN - Rev. 5
11 / 33
Firmware Version
Serial Number:
ID number of the device.
Last Firmware Upgrade:
Last firmware update date.
Protocol Version:
Version identifier of the communication protocol supported by the device.
The buttons grouped on the right has the following features:
Device Identification:
If enabled, it will identify the device connected by blinking the led for approximately 10 seconds.
Figure 11.
Firmware Upgrade:
When it is enabled, allows the firmware upgrade.
Figure 12.
Bootloader Upgrade:
In order to upgrade the bootloader it is essential not disconnect the device during the update
process.
The application disable the access to certain functionality by disabling the buttons shown when the firmware type APP is not
installed or it is an incompatible version and the bootloader is not installed.
C.4.4.4.
Configuration of the Unit
Figure 13.
The Groupbox configuration contains all the information of the device. The values shown are only modifiable through the
Configuration Wizard.
The fields displayed are:
1.
Name: Configuration Name.
2.
Last: Last change date.
3.
Network Pin: code identification of the network to a set of wiAutoLink. Range [0000-9999]. The network pin must be different
between near outdoor stations. This Pin is used to identify each wiAutoLink group.
4.
Device Type: Identifies the type of device configuration. It can be set SinglePhase, BiPhase or ThreePhase.
5.
Device ID: device identification within the same network. Range [1-3].
6.
Pickup Current [A]: Nominal current of the network of devices. Range [5-200].
7.
Frequency Setting [Hz]: Nominal frequency of the network of devices. Range [50/60].
8.
Counts: Number of faults (≥ Preset C 10%) to be detected prior the line interruption. Range [1-4]. Default value 2