ABB TZIDC-110, Руководство по эксплуатации

Страница: 28 / 59

28 Electro-pneumatic positioner TZIDC-110 41/18-77 EN
3.4.3 Requesting information
Additional information can be called up for display by briefly pressing the buttons shown
in the table when the bus mode is active (i.e. the following display is seen):
3.4.4 Local operation (bus device)
Procedure for mode selection from operating level:
• Press and hold
MODE
.
• Additionally briefly press as often as required.
The selected operating mode is indicated.
• Release
MODE
The position is indicated as a percentage or rotation angle.
Overview
*) Positioning not active
**) For quick motion: Press and together.
Buttons pressed Action
Cyclic communication:
The setpoint value in % and the setpoint state are indicated.
Acyclic communication:
The communication state is indicated.
The operating mode on the bus and the bus address are shown.
The software revision level is indicated.
Mode Mode display Position display
1.1
Positioning with fixed setpoint. Setpoint
can be adjusted by pressing or .
1.2
Manual adjustment* within the opera-
ting range. Press or to adjust.**
1.3
Manual adjustment* within the sensor
range. Press or to adjust.**
conf
mA
%
C °
ENTER
conf
mA
%
C °
conf
mA
%
C °
conf
mA
%
C °
conf
mA
%
C
°
conf
mA
%
C
°
conf
mA
%
C
°