ABB TZIDC-110, Руководство по эксплуатации

Страница: 13 / 59

41/18-77 EN Electro-pneumatic positioner TZIDC-110 13
Follow the procedure (steps 1 - 5) below to attach the positioner to a linear
actuator:
1. Mount the follower guide to the actuator
2. Assemble the lever (if not yet pre-assembled)
• Fasten the follower guide (1)
and the clamp plates (2) with
screws (4) and spring washers
(3) to the spindle of the actua-
tor; hand-tighten the screws.
• Slip the spring (2) onto the bolt
with the follower pin (1).
• Slip the plastic washer (3) onto
the bolt and compress the
spring with it.
• Insert the bolt with com-
pressed spring into the oblong
hole in the lever (4) and fasten it
in the desired position using the
plain washer (5) and nut (6) at
the lever; the scale on the lever
indicates the link point for the
stroke range.
• Slip the plain washer (8) onto
the screw (7), insert the screw
into the lever and counter with
the nut (9).
4
2
1
3
Fig. 5 Mounting follower guide to actuator
1
2
3
4
5
6
9
8
7
Fig. 6 Assembling the lever