HE.17454 / TA04928 D Page 7 of 12
CAUTION
WARNING
WARNING
WARNING
WARNING
Inspect tool and dies before use. Replace any worn
or damaged parts. A damaged or improperly assem-
bled tool can break and strike nearby personnel.
Failure to observe this warning could result in severe
injury or death.
Electric shock hazard:
This tool is not insulated. When using
this unit on or near energized electri-
cal lines, use proper personal protec-
tive equipment.
Failure to observe this warning could
result in severe injury or death.
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from flying
debris.
Pinch points:
• Remove battery before changing
dies, adapters, or jaws.
• Keep hands away from the crimping
tool head when crimping.
Failure to observe these warnings could
result in severe injury or death.
• Allow approximately 3 to 5 minutes of time to cool
down as tool automatically switches off when it gets
too hot.
• Do not secure this tool in a vise. This tool is
designed for hand-held operation.
• Use this tool for the manufacturer’s intended
purpose only.
Failure to observe these precautions may result in
injury or property damage.
Charging the Battery
Read the instructions supplied with the battery charger.
LED Work Light (white)
This LED automatically turns on when the trigger is
pulled. It remains on for 10 seconds after the trigger is
released.
LED Indicator (red)
This tool is equipped with a special circuit board
incorporating several important features to inform the
user about the current status of the unit. The LED
signals in the following cases:
When
What it means
2 x
After
inserting
the battery
Battery is
inserted in tool
20 sec
After
working
cycle
Low battery
20 sec/2 Hz
Contact
TNB service
20 sec/5 Hz
20 sec/5 Hz
Tool has become
too hot
1 x
1 x
After
interruption
Error – manual
interruption of
crimp cycle prior
to completion
3 x
3 x
After
working
cycle
Error – automatic
opening of tool
due to exceeding
crimp force
OPERATION
2.2
