1 0
S P I R I T
I T
F L O W - X
I N S T R U C T I O N M A N U A L | I M / F L O W X - E N
Maintenance and cleaning instructions
Important - please read the following notes:
Safe operation of this product can only be guaranteed if
it is properly installed, commissioned, used and
maintained by qualified personnel in compliance with
the operating instructions. General installation and safety
instructions for pipeline and plant construction, as well as the
proper use of tools and safety equipment must also be complied
with.
Every effort has been made during the design of the flow
computer to ensure the safety of the user but the following
precautions must be followed:
1
Ensure correct installation. Safety may be compromised if the
installation of the product is not carried out as specified in
this manual.
2
The flow computer is designed as an installation category I
product (24V max). The flow computer may not be used for
measurements within measurement categories II, III and IV.
3
A disconnecting device (switch or circuit breaker) must be
included in the installation. It must:
–
Have a rating with sufficient breaking capacity.
–
Be in close proximity to the equipment, within easy reach of
the operator but not cause difficulty in operating.
–
Be marked as the disconnecting device for the flow
computer.
–
Not interrupt a protective earth conductor.
–
Not be incorporated into a mains supply cord.
4
This product is designed and constructed to withstand the
forces encountered during normal use. Use of the product
other than as a flow computer, or failure to install the product
in accordance with these Instructions, product modifications
or repair could:
–
Cause damage to the product / property.
–
Cause injury or fatality to personnel.
–
Invalidate the marking.
5
Spirit
IT
Flow-X products are not intended to withstand
external stresses that may be induced by any system to which
they are fitted. It is the responsibility of the installer to
consider these stresses and take adequate precautions to
minimize them.
6
Environmental protection of the Spirit
IT
Flow-X enclosures is
in accordance with IEC 60529 IP50. The flow computer should
be installed in a dry and clean room.
7
Dust the flow computer by wiping the screen and the body
with a soft, clean antistatic cloth. For more difficult cleaning
situations, use a 50/50 mix of water and Isopropyl alcohol.
CAUTION:
Spray the cleaner onto a cloth and use the
damp cloth to gently wipe the surface. Never spray the
cleaner directly on the screen surface. It may run behind
the bezel and may result in fire, electric shock or damage to the
electronics.
CAUTION
: Do not use cleaners that contain any
petroleum based materials such as benzene, thinner, or
any volatile substance to clean the screen or body. These
chemicals may damage the flow computer.
These instructions must be stored in a safe place near the
installation of the flow computer at all times.
Figure 3-10 Flow-X/R label
