ABB PVS800-IS, Руководство по оборудованию, Страница: 23 / 68

Transporting
Obey these instructions and the additional information given in section Dimensions and
layout (page 58) :
• Protect the inverter station with wooden corners, plastic film, etc. The inverter station
is delivered unpacked from the factory as standard.
• Protect the interior of the inverter station from rainwater by using temporary protection
plates on air intakes and outlets.
• The PVS800-IS inverter station is built into a 20 foot HC (high cube) sea container form.
The inverter station can be transported on a dedicated sea container trailer using the
standard container attachment system.
• If not using a dedicated sea container trailer: Lay the inverter station directly on the
transportation chassis to prevent sliding and to keep the height as low as possible. Use
friction enhancement mats (rubber) below the inverter station. The maximum thickness
of the mat is 3 cm. Fasten the inverter station firmly onto the chassis with heavy-duty
transport straps.
WARNING!
Transport the inverter station on an open heavy-duty chassis. Do not use an
enclosed trailer because the inverter station could easily get scratched if it comes
into contact with the walls of the trailer.
Keep the transportation height as low as possible. Make sure that the total height
of the transportation is not above the maximum allowed height for the planned
route.
Do not throw hooks over the roof. This can damage the paint and lead to corrosion.
Incoming inspection at arrival
Visually check for potential transportation damage. Mark and record any damage carefully
and inform the local ABB or ABB sales contact immediately. Repair any damaged paint.
See section
Checking and repairing painted surfaces (page 50) .
Check that the unit corresponds to the delivery list and order. Record deviations carefully
and inform the local ABB or ABB sales contact immediately.
Storing, lifting and transporting 23