ABB Platinum standard Series, Инструкция по эксплуатации

Страница: 78 / 122

TROUBLESHOOTING
ERROR MESSAGES AND CORRECTIVE ACTION
6 - 6 WBPEEUI110504A0
Low output or no output
(continued)
Pressure piping. Check that pressure connection is
correct.
Check for leaks or blockage.
Check that blocking valves are
fully open and bypass valves are
tightly closed.
Check for entrapped gas in liquid
lines and for liquid in dry lines.
Check that density of fluid in pres-
sure piping is unchanged.
Check for sediment at transmitter
process connection.
Device in digital mode. If analog output is desired, config-
ure the transmitter using CONFIG-
URE key, then press SEND
CONFIG.
Transmitter electronics
connections. Check for shorts in cell leads.
Make sure pins and receptacles
are clean.
Check cell connections.
Transmitter electronics failure. Press STATUS key and refer to
Table
6-1 and Figure 6-1 .
Cell. Press STATUS key and refer to
Table
6-1 and Figure 6-1 .
Table 6-2. Output Troubleshooting
(continued)
Fault Probable Cause Corrective Action