Start-Up Procedure
17
iii. External Trigger address setting
If a Parallel Input/Output (PIO) board is installed in the computer, set the parameter
trig pio address
to the
proper I/O address in decimal
notation. To know which address to use, please refer to the PIO card
documentation.
5. SHUTDOWN SEQUENCE AND SYSTEM PACKING
To shut the system down, you simply need to exit the acquisition software, turn the computer and the
spectroradiometer OFF.
To prepare the spectroradiometer for shipment, the following assemblies must be removed and properly placed
in their respective carrying case:
Data cable
Input telescope
Detectors
Cold Source
Eye piece or CCD camera, power supply and monitor
IMPORTANT: Turn the spectroradiometer off before removing the detectors.
Before moving the spectroradiometer into its carrying case, make sure the cold source window is protected. The
same precaution applies for the input window if the input collimator is not installed. Also, place each accessory
into a plastic bag giving added protection against dust and other particles.
