ABB FSCA-01, Руководство пользователя

Страница: 13 / 52

Drive configuration
13
Drive configuration
Overview
This chapter gives information on configuring the FSCA-01 RS-
485 Adapter Module for use with Modbus/RTU.
Modbus connection configuration
After the adapter module has been mechanically and electrically
installed according to the
FSCA-01 RS-485 Adapter Module
Hardware Manual (3AUA0000044521 Rev A [English]), you must
prepare the drive for communication with the module.
The detailed procedure of activating the module for Modbus
communication with the drive depends on the drive type. Normally,
you must adjust a parameter to activate the communication (see
the drive documentation).
As communication between the drive and the adapter module is
established, several configuration parameters are copied to the
drive. You must first check the parameters listed in the following
parameter tables and adjust them where necessary. The
alternative selections for these parameters are discussed in more
detail below the tables.
Note: The new settings take effect only when the module is
powered up the next time or when a Fieldbus Adapter parameter
refresh command is given (see the drive documentation).