ABB ADC-90-200-C1, Руководство по эксплуатации и установке

Страница: 61 / 117

6.3 Reset the EVSE after an emergency
Preliminary requirements
• Owner
Procedure
1. Make sure that the situation is safe again.
2. Turn the emergency button clockwise to release it.
• The EVSE starts.
• The message disappears from the touchscreen.
• The EVSE resumes the normal operation.
6.4 Charge session
6.4.1 Charge an EV
Preliminary requirements
• Owner
Procedure
1. Park an EV in the parking space. Make sure that the connector of the EV charge
cable can reach the connector on the EV.
2. Energize the EV.
3. Start the charge session. Refer to section 6.4.2 .
4. Stop the charge session. Refer to section 6.4.3 .
6.4.2 Start a charge session
Preliminary requirements
• Owner
Procedure
1. On the touchscreen, select the applicable
connector button.
Note: If you skip this step, the EVSE selects the correct connector
automatically when you connect the EV charge cable to the EV.
2. Remove the EV charge cable from the EVSE.
3. Connect the EV charge cable to the connector on the EV.
4. On the touchscreen, press the
Start button.
5. If the touchscreen shows a message to authorize the charge session, do the
instruction that the touchscreen shows.
The EVSE charges the EV and shows the progress on the touchscreen.
Operation
9AKK108466A3703-EN | 001 59