A&D GP-100K, Инструкция по эксплуатации

Страница: 63 / 98

61
Recalling the memory data
Confirm that the “Data memory ( data )” parameter is set to “ 2 ”.
1 Press and hold the PRINT key until
reCall
is displayed, then release the key.
2 Press the PRINT key to enter the memory recall mode. The type of data appears in the upper
left of the display as shown to the right:
Recall the data in memory using the following keys
RE-ZERO key To proceed to the next data set.
MODE key To go back to the previous data set.
PRINT key To transmit the current data using
the RS-232C interface.
With SAMPLE held down, press the CAL key
To delete the data currently displayed.
Note: Deleting the data will not increase the number of data that can be stored.
CAL key To exit the memory recall mode.
3 Press the CAL key to return to the weighing mode.
Transmitting all memory data at one time
Confirm that the “Serial interface ( 5if )” parameters are set properly. For details, refer to “9.
FUNCTION TABLE” and “15. CONNECTION TO PERIPHERAL EQUIPMENT”.
1 Press and hold the PRINT key until reCall is displayed,
then release the key.
2 Press the SAMPLE key to display out .
3 Press the PRINT key to display
Sout no
with “
no
” blinking.
5 Press the RE-ZERO key to display out go with “ go ”
blinking.
6 Press the PRINT key to transmit all data using the RS-232C
interface.
7 The balance displays
Clear
when all data is transmitted.
Press the CAL key to return to the weighing mode.
Deleting all memory data at one time
1 Press and hold the PRINT key until reCall is displayed, then release the key.
2 Press the SAMPLE key several times to display Clear .
3 Press the PRINT key to display
SClr no
with “
no
” blinking.
4 Press the RE-ZERO key to display SClr go with “ go ” blinking.
5 Press the PRINT key to delete all data
6 The balance displays
end
, then
reCall
when all data is deleted.
7 Press the CAL key to return to the weighing mode.