![background image](http://html1.mh-extra.com/html/aandd/ad-8552eip/ad-8552eip_instruction-manual_3074539005.webp)
5
This unit with a protective cover
This unit
How to remove the protective cover
Protective cover
①
This unit
Protective cover
1-2
Cautions
Before use, confirm the following articles for safe operation.
Grounding The Converter
Be sure to ground this converter.
Separate this earth ground line from others, like ground line of a motor, inverter or a power source. Unless the
converter is grounded, it may result in receiving an electric shock, cause operation error or catch fire.
Proper Power Source And Power Cable
Confirm the AC voltage, frequency and power tolerance of the power cable (refer to “4. Power Terminal”). If the
voltage range of the cable is lower than the power line voltage, it may cause leakage or catching fire. Use pole
compression terminals to connect the power cable to the terminals.
Splashing Water
The module is not water-resistant type.
Flammable Gas
Do not install the converter where flammable gas is present.
Heat Radiation Of The Module
Space out instruments to radiate heat sufficiently.
Do not use in an environment where the ambient temperature exceeds the operating temperature range [-10
℃
to
+50
℃
, 85% RH or less (no condensation)].
This unit is covered with a transparent plastic protective cover at the time of shipment.
After installing and connecting, be sure to remove the protective cover before turning on the power.
If it is used without removing the protective cover, this unit will overheat.
The protective cover is for preventing the entry of wire scraps and the like during installation and connecting.
Do not remove it until installation and connecting are complete.
②
Remove the two tabs on the lower
surface of the protective cover and
remove the protective cover.