A&D AD-4961-2KD-2035, Инструкция по эксплуатации

Страница: 74 / 108

72
8.2.8. Processing number
Enter the number of products to weigh in one minute.
When the number is entered, the belt speed will be calculated automatically using the value and the weighing
conveyor length.
8.2.9. Speed
Enter the belt speed of the conveyor.
When the speed is entered, the processing number will be calculated automatically using the speed and the weighing
conveyor length.
8.3. DO Map
DO map sets whether or not to stop the conveyor according to the judgment result and DO related items.
For details, refer to “4.6.5. Setting the digital output (DO).”
DO map only will not activate the output circuit. Be sure to set DO behavior as described in “8.4. DO Behavior.”
8.3.1. Outputting requirements
OK: Outputs when the weighing result is OK.
Over: Outputs when the weighing result is overweight.
Under: Outputs when the weighing result is underweight.
Detect Two: Outputs when next product is conveyed to the weighing conveyor before the weighing value of the
previous product is confirmed.
Unsplit: Outputs when the product length is longer than the specified product length.
Metal: Outputs when the input to DI, which is assigned to metal detection, is confirmed.
External 1: Outputs when the input to DI, which is assigned to external 1, is confirmed.
External 2: Outputs when the input to DI, which is assigned to external 2, is confirmed.
Belt in motion: Outputs when the belt is moving.
Belt stopped: Outputs when the belt is stopped.
In Modbus setting, assignment to each bit (4 bytes) is shown below. Set the bit to assign to 1.
High-order bit Low-order bit
31 to10 9 8 7 6 5 4 3 2 1 0
0
Belt
stopped
Belt
in
motion
External
2
External
1
Metal Unsplit
Detect
Two
Under Over OK
e.g.: To assign Metal, Under and Over to DO1
2
5
+2
2
+2
1
=38 (DEC)
Have a 4-byte access to address 40051 and write 38(DEC).