A&D AD-4329A, Инструкция по эксплуатации, Страница: 44 / 56

Page 42
AD-4329A Weighing Indicator
11. Standard Serial Data Output (SER.OUT)
The standard serial data output can be used to output the data to an A&D printer and
a display unit.
Set the
f-30
~
f-34
of the F-Functions to use this output.
When using a non-buffered printer like the AD-8117, AD-8117A and AD-8121 etc, the
printer can not receive data while printing. Therfore, set to
f-33 1
for the manual print
mode or auto print mode.
Pin No. Signal
3 pin
5 pin
Current loop
Other pins Not used
Case Shield
Inside of AD-4329A
Related Functions
F-Function Description
f-30 0 Displayed data
f-30 1 Gross data
f-30 2 Net data
f-30 3 Tare value
Output Data
f-30 4 Gross data / Net data / Tare value
Output mode
F-Function Description
Stream mode
f-31 0 Description of "Stream Mode" at page 31
Auto print mode
f-30 1 Description of "Auto Print Mode" at page 31
Manual print mode
f-30 2
When pressing the
PRINT
key each time, the data is output once.
Auto-print condition
F-Function Description
Positive data only
f-32 0
"Inhibition region of output" +5d.
+5d < "permission region of output".
Positive and
negative data
f-32 1
-5d "inhibition region of output" +5d.
"Permission region of output" < -5d, +5d < "permission region of output".
F-Function Description
f-33 0 Not used Delay for continual
data
f-33 1 Approximately 2 seconds
Baud rate f-34 600 bps, 1200 bps, 2400 bps
CF-Function Description
Cf-07
Data output of tare
Cf-08
Output on over load and unstable state. Use or not used
Cf-09
Format of Header Selection of
TR
,
PT
,
GS
,
NT
,
T
,
G
and
N
Cf-10 Figure number of unit, decimal point Two figures or three figures, dot or comma
11. Standard Serial Data Output