A&D AD-4329A, Инструкция по эксплуатации, Страница: 25 / 56

AD-4329A Weighing Indicator
Page 23
5.5. Gravity Compensation Function
If the scale is used at the calibration location, it is not necessary to perform this function.
It may cause a weighing error, if there is a difference of gravity acceleration
between the installed location and calibration location. This function specifies
these gravity accelerations and corrects span error.
Caution The decimal point is not displayed in the function. Ex.
9798
= 9.798 m/s
2
Step 1 Press the
CAL
key in normal weighing mode. The
Cal in
is displayed for two seconds. Press the
M+
key to enter the gravity compensation function.
If you want to cancel the current procedure, press
and hold the NET/GROSS key and press the
CAL
key.
Then, all parameters are not changed and the
calibration mode is finished. Press the Operate/Standby key
to turn the display off after displaying
CanCel .
Step 2 The parameter
g1
xxxx
is displayed. Enter the
gravity acceleration of the calibration location. The
parameter xxxx is the gravity acceleration.
key...........The key to select a figure.
key ...........The key to select a number.
key...........The key to store the new gravity
acceleration and proceed to step 3.
MODE
key ......The key not to change the value
and proceed to step 3.
Step 3 The parameter
g2 xxxx
is displayed. Enter the
gravity acceleration of the installed location. The
parameter xxxx is the gravity acceleration.
key...........The key to select a figure.
key ...........The key to select a number.
key...........The key to store the new gravity
acceleration and proceed to step 4.
MODE
key ......The key not to change the value
and proceed to step 4.
Step 4 Now
g1 xxxx
is displayed. Press the
CAL
key to
store the parameters. The
end
is displayed.
Proceed to step5.
Step 5 Press the
Operate/Standby
key to turn display off.
5.5. Gravity Compensation Function