®
Aluminum Athletic Equipment
1000 Enterprise Drive, Royersford, PA 19468
Toll Free: (800) 523-5471 Phone: (610) 825-6565
www.aaesports.com
Lower Horizontal
Cable Collar
w/ Anchor Shackle for
Crimped End Loop
Lower Vertical
Cable Collar
w/ Tensioner
Assembly
(see collar orientation
detail)
Front
View
Debris Ring
(Optional)
If not present
Make sure
lower collars
are positioned
accordingly.
3'-6"
42"
(REF)
10'-0"
120"
Left
View
Post Cap
pre-installed
Cleat
Detail
10
7
6
9
9
Apply
supplied
Anti-Seize
to bolt
threads
Eyebolt
Detail
3
4
5
Apply supplied
Anti-Seize to bolt
threads
Open
Eyebolt Collar
Detail
AAE I.D.
Label
Warning
Label
Cleat
(for positional ref)
90.00°
40.00°
Installation Notes:
Lower Collars:
From bottom of pole slide
1.
the lower vertical cable collar, lower
horizontal collar and and debris ring
(
optional
) into position. To allow proper
insertion into ground sleeve, lower most
collar should be 42" from end of post.
Before securing collars into place make
sure to rotate the lower vertical collar
approx 40°.
(
refer to diagram
)
Cleat:
Is to be installed so that it is on
2.
backside of post, opposite net. Screws will
be inserted through post and cleat and
secured on opposite of net side using self
locking hex-nuts and cap nuts. (
refer to
diagram
)
Mid Collar Open Eyebolt:
Note
3.
orientation of collar on post. From top of
pole slide the open eyebolt collar into
position (
refer to diagram
) and secure
into place.
Mid Collar with Shackle:
Note orientation
4.
of collar on post. From top of pole slide the
open eyebolt collar into position and ,
rotate approx 45° clockwise (
refer to
diagram
) and secure into place.
Eyebolt:
Pulley system comes
5.
preassembled to eyebolt. Install washer
onto eyebolt then insert eyebolt with
washer through front side of hole at top of
post. From opposite side secure eyebolt
into place using a flatwasher and Nylock
hex-nut. (
refer to diagram
)
Upper Collar:
From top of pole slide the
6.
upper vertical cable collar into position
(collar should rest on eyebolt washers).
Before securing into place make sure to
rotate the collar approx 40°. (
refer to
diagram
)
Make sure warning labels are present on
7.
goal posts.
Note:
Post assembly should be
done with post laying down
on flat level surface.
1
Note: Collars are Black in color,
shown in different colors to aid in
identification.
Anti-Seize
(supplied by AAE
Collar Orientation
Detail
(Note:
ONLY
vertical cable
collars should be turned away
from netting, this aids in
tensioning the net)
BBS-25/SA
Assembly Instruction
Right End Post
18 of 25
