AAD Vigil Cuatro, Руководство пользователя

Страница: 27 / 48


For Example :
2 3
English
Action Result
1. Push
Short flash
➯
(2)
2. Push Short flash
➯
(3)
3. Push Short flash
➯
(4)
4. Push « Goodbye » followed by « Vigil » are displayed before the AAD shuts down.

3.5.9. Shut down. (The shut down procedure is similar to the start up procedure)

« Sys OFF»
A quick press of the push button after each LED flash (4 times) will shut down the Vigil
®
Cuatro.
On the first press the « SysOFF » message is displayed. Press the button a second and third time; do this as soon as the
red LED flashes.
Press the button as soon as the red LED flashes a fourth and last time. The display will show « Goodbye » followed by
« Vigil » for a few seconds. Finally, the green LED flashes very briefly and then the Vigil
®
Cuatro shuts down.
If the LCD pixels are inverted on the ground and prior to take off, your Vigil
®
Cuatro is Airborne and therefore not
reading the correct Ground Zero reference. In this case, you must switch off and restart your Vigil
®
Cuatro , to get the
correct Ground Zero reference.
The Vigil
®
Cuatro is now ready for use and is in a stand-by status. While in stand-by status, the unit re-calibrates itself every
2 minutes. After take-off the Vigil
®
Cuatro will become armed once 1000 . ft above “ground zero” reference is reached, if no or
a positive altitude correction is implemented. When a negative altitude correction is implemented, the Vigil
®
Cuatro will
become armed 1000 ft above the preset negative altitude correction (see page 8 § 3.1.)
After take-off (max 32 sec. above 90 ft) the Vigil
® Cuatro will go in to fast measuring mode (Airborne status).
You can notice this when the LCD pixels invert. (see image on page 30 )
« Sys OFF»
« Sys OFF»
For 2 minutes after each landing, your jump information will be displayed (Last FF time & speed). LCD pixels remain
inverted. This same jump information is accessible at any time (displayed for 30 sec.) by pushing the LCD button once.