PAGE 8
I
NSTRUCTION MANUAL
AAPRODUCTS INC.
F
or Technical Support Call:1-888-806-3972
/
626-332-4245
S
TEP 1
Use the proper tool, take off the cover on the roof top to locate a hole (thread / non-thread). Place a Rubber
Seal for each hole. Set position for the Adapter Base: Connect the Base Bracket, Adapter Base and the
Mounting Base with two Carriage Bolts M8*30 upside down, tighten with Nuts & Washers M8. ( See FIG 6 )
Nut
Alignment Hole
Optional: Place a Rubber
Seal for each hole.
FIG 6
S
TEP 2
Align the middle hole of the Mounting Base to the vehicle
’
s roof hole (thread / non-thread): With thread, put the Bolt M8*45
through and tighten the bolt( See FIG 7-1 ); Non-threaded, put the Bolt M8*45 through and tighten with Nut, Washer and the
Rubber Seal. ( See FIG 7-1,7-2 )
After installing the rack set, adjust all the Cross-Bars to align with each other
and tighten all fasteners
. Insert the Rubber
Sealing Strip into the Cross-Bar’
s upper & lower channel to reduce wind-noise. Cut the right length as needed.( See FIG 7-3 ).
Carriage Bolt M8 * 30
Washer M8
OUTSIDE OF THE ROOF
INNER OF THE ROOF
Bolt M8 * 45
&
Spring Washer M8
&
Washer M8
Rubber Seal
&
Washer M8
&
Nut
FIG 7-1
FIG 7-3
FIG 7-2
Insert the Rubber Sealing Strip into the
Cross-Bar’s
Upper & Lower Channel
to reduce
wind-noise. Cut the right length as needed.
FORD TRANSIT CONNECT
