PAGE 9
I
NSTRUCTION MANUAL
AAPRODUCTS INC.
F
or Technical Support Call:1-888-806-3972
/
626-332-4245
S
TEP 1
Find the threaded holes on the roof. They are a pair of M6 threaded holes on each corner. Take out the covers ( if any ).
Optional: Put a Rubber Seal on each hole to improve sealing. ( See FIG 8 ). Set position for the Adapter Base: Align both
side-holes of the Adapter Base to the roof’
s pre-thread holes. ( See FIG 8-1 )
FIG 8
S
TEP 2
Align both side-holes then connect the Mounting Bases and Adapter Bases, put two M6*40 Bolts through and tighten
the bolts to secure the rack with the vehicle, tighten the bolts with Washers M6 & Spring Washers M6. ( See FIG 9-1 ).
After installing the rack set, adjust all the Cross-Bars to align with each other and tighten all fasteners. Insert the
Rubber Sealing Strip into the Cross-Bar’
s upper & lower channel to reduce wind-noise. Cut the right length as needed.(
See FIG 9-2 ).
Optional: Place a Rubber
Seal for each hole.
Alignment Hole
FIG 9-1
Bolt M6 * 40
Spring Washer M6
Washer M6
VAN ROOF
Insert the Rubber Sealing Strip into the
Cross-Bar’s
Upper & Lower Channel
to reduce
wind-noise. Cut the right length as needed.
FIG 9-2
MERCEDES BENZ METRIS
