EmbeddedBlue 500
47
Copyright ©2003 A7 Engineering, Inc.
9.
Establish a connection from the
PC
to the
Board of Education
.
Please see the section titled Connecting a PC with an eb600 to a Board of Education
for information on establishing the connection.
10.
Using HyperTerminal, type a series of
characters
.
These characters will be transmitted over the wireless link, read by the BASIC Stamp
application, and then displayed in the debug window (Figure 10).
Figure 10: HyperTerminal Input and Debug Output
Step 2: Transmit Data from the BASIC Stamp to the PC
In this step we will create a BASIC Stamp application to send data out the eb500 to
the PC where we will use HyperTerminal to display the data received by the eb500
module attached to the eb600 on the PC.
1.
Reset the
eb500
attached to the
eb600 PC Adapter
to place the eb500 into
command mode.
To reset the eb500 attached to the eb600 PC Adapter, disconnect the power, wait a
couple of seconds, and then reconnect the power.
2.
Reset the
eb500
attached to the
Board of Education board
to place the eb500 into
command mode.
To reset the eb500 attached to the Board of Education board, disconnect the power,
wait a couple of seconds, and then reconnect the power. The Reset push button on
the Board of Education board will NOT reset the eb500.
