a2b Blake, Руководство пользователя

Страница: 3 / 20

3
Please read it carefully before your first trip.
Your A2B should be properly assembled and charged before your first trip. In case of ambiguity or obvious
defects, please contact us immediately, otherwise your warranty will expire. Please make sure that all A2B users
read and understand the following important information.
According to the Road Traffic Licensing Regulations, a bicycle must be equipped with two independent,
functional brakes, a clearly audible bell, headlamp, taillight, pedal reflex reflector, side reflectors for wheels or
integrated light strips on the tyre as well as front and rear reflectors.
The A2B is suitable for driving on paved roads and pathways. Do not drive off the beaten track or off-road. A2B
mountain bikes can also be used off-road.
Do not use the A2B for water crossings, cross-country jumps or sporting events.
We recommend that you wear a certified bicycle helmet when using the A2B at all times and that you wear
bright or reflective clothing at night.
Make sure that you know and observe the rules of conduct for safe and responsible driving. When driving with
the A2B, there is always a risk of serious / fatal injury or damage to property caused by an accident. By deciding
to use the A2B, you assume full responsibility for this risk.
This user's manual does not guarantee the safe use of the A2B in all conditions.
3. components on the bike and adjustment features
3.1 Replacement of components, mounting of accessories
Before installing any components or accessories (including other tyres), check with your dealer to see if they are
suitable for your A2B. Read and follow the instructions for each component or accessory you have purchased
for your A2B. Follow the manufacturer's instructions for the components or accessories if they differ from these
instructions.
As with all mechanical components, your A2B is subject to a certain amount of wear and tear. Particularly at
higher loads, wear characteristics must be taken into account. If a component's service life is exceeded, this can
lead to an unexpected loss of function of the component, which can result in serious or even fatal injury.
For this reason, pay attention to wear and tear such as cracks, scratches and colour changes in highly stressed
areas on the frame, fork, wheels and handlebars, which indicate that the service life has been reached or
exceeded. Have worn components replaced immediately by your dealer.
Failure to test, install, use and maintain any components or accessories properly may result in serious or even
fatal injury.
Use of non-original components or spare parts may endanger the driving safety of your A2B and void the
warranty. Replacement of components or the attachment of accessories is at your own risk, as these parts may
possibly cause damage to the equipment. have not been tested by Hero Eco for suitability, reliability or safety
with your A2B
.
3.2 Adjusting the brake levers
Can you operate the brake levers comfortably? If this is not the case, take your A2B to a dealer and ask them to
adjust the angle of the brake levers. Otherwise, you can adjust the angle of the brake levers yourself as follows:
Loosen the screw under the brake lever with a suitable Allen key.
Adjust the angle as required.
Tighten the screw again and make sure that the brake lever is securely fixed in position.
Before a short test drive, check that the brake levers are firmly seated and that they cannot be twisted. To
adjust the brakes yourself, you should take your A2B to a dealer.