7
Operation Instructions
NOTICE:
Please make sure the water has been fully filled into the tank and power cord is well connected.
Then make sure the water heater stand still for at least 30 minutes before powering up.
Electronic Controller Operation
1. Initial Power On
For the first-ever power connection.electronic
controller will run self-inspection program. All
indicators on the screen will light up and last for a
few minutes and then power-off. ( Figure 7)
Note
If the water heater is powered off (power outage or
power supply disconnected), when the water heater is
recycled, the temperature, timer, AES, operating
mode settings will return to the states before power
off.
2. Power On/Off
Press Power
ON/OFF button, the heater will
be power-on. Setting temp and actual temp will be
displayed a few seconds later. ( Figure 8)
When heater is power on, pressing Power ON/OFF
button turn the heater into power-off status.
Default settings: Temperature at 65
℃
, Clock at
12:00.
Figure 7
Figure 8
3. Temperature setting
With the power on, press “
” or “
” to increase or decrease the set temperature by 1
℃
. Press and hold
the buttons to change the set temperature continuously and release to stop changing. The temperature range
is 35
℃
-75
℃
.
4.Timing
Prior to timing, clock should be set to the standard time. With the power on, Press “ ” button to display
the clock, and then press it repeatedly to display “TIMER 1”, “TIMER 2” “TIMER 1+TIMER 2” in a
sequence.
Power Switch
Increase
Hot Water Amount Display
Decrease
AES Function
Heating Indicator
EFFICIENCY
1
2
SETTING
PROGRAM
INSTANT
MODE
PUMP
HYBRID TURBO
P U M P
SETTING
PROGRAM
INSTANT
MODE
PUMP
PROGRA
“
”
