CARE
To clean system manifold, wipe exterior with a damp cloth. Do not
use any strong abrasive cleaning agent or solvent cleaner.
NOTICE
Safeguards
•
If you experience a hose connection leak, disconnect and
re-set the hose.
•
Must replace filter housings every 5 years or risk property
damage from leaks. Call 800.821.2017 to order.
•
Do not use with water that is microbiologically unsafe or of
unknown water quality without adequate disinfection before
or after the system.
•
Systems certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
CARE & SAFEGUARDS
INSTALLATION GUIDE
NEED HELP? GIVE US A CALL
877.333.7108
STEP 1
Prepare for Installation
STEP 4
Reattach Sumps
1
2
1
2
3
1
2
1.
Turn off COLD water valve (1).
Release pressure from system by
turning on dedicated faucet until
water stops flowing (2).
2.
Unbox filter cartridge replacements
and remove plastic.
Reattach sumps to system manifold with
Stage 1 on the left and Stage 2 on the right.
Make sure connection points are aligned,
push top of sump into bottom of system
housing, and twist to the right. Ensure that
each sump is fully attached and locked in.
Note: Ensure sumps are not on an angle
while reattaching. This may result in
damage to the o-ring.
STEP 2
Remove Filter Cartridges
STEP 5
Replace Battery
1.
Remove each sump from the unit
housing by rotating the sump to the
left and pulling down.
2.
Holding the sumps over the sink,
unscrew the top of the sump from
the bottom by turning the bottom
portion to the right. Pour excess
water down the drain. Then, pull
down on each filter cartridge to
disconnect the filter cartridge from
the top half of the sump.
3.
Discard both filter cartridges.
Note: If sumps are too tight to
disconnect by hand, please use
the plastic wrench included with
original system.
Open battery door and remove old battery.
Insert new battery with the positive side
facing to the back. When inserted properly,
the system will beep five times and blink red.
STEP 3
Insert Filter Cartridges
STEP 6
Flush and Check for Leaks
1.
Press new filter with clear
netting to the top of the Stage
1 sump. Reattach the bottom of
the sump by ensuring connection
points are correctly aligned, then
turn to the right to tighten.
2.
Continue this step for Stage 2
using the new filter with the
blue netting.
Note: Do not use tools to
tighten. Hand tighten only.
Slowly turn on COLD water supply. Turn off
dedicated faucet and check for leaks. Then,
turn on dedicated faucet and leave water
running to flush cartridges for 10 minutes
or until water is clear of carbon fines.
Note: Do not drink flushed water.
Scan to view AO-US-200
replacement video.
