A.O. Smith ADMR-40, Инструкция по установке, эксплуатации и обслуживанию

Страница: 85 / 98

Instruction manual ADMR 85
s
5. Undo the screws on the draught diverter.
6. Remove the draught diverter from the appliance.
7. Undo the screws of the lid in the top side of the appliance.
8. Remove the lid from the appliance.
9. Remove the sealing ring from the appliance.
Warning
The flue baffles can be hot.
1. Remove the flue baffles from the appliance.
2. Check the flue baffles for the presence of corrosion, removing this if
necessary.
3. Check the flue baffles for wear, and replace the flue baffles if necessary.
4. Place a new sealing ring on the rim of the tank and re-fit the lid.
5. Fit the draught diverter
(3.9.2 "Fitting the draught diverter") .
6. Fit the flue damper (3.9.3 "Fitting the flue damper") .
7. Fit the flue gas sensor (3.9.4 "Fitting the flue gas sensor") .
8. Re-fit the protective cover.
15.5 Finalizing
maintenance
To finalize the maintenance carry out the following steps:
1. Fill the appliance
(5 "Filling") .
2. Start the appliance (9 "Starting and running") .
3. Erase the message
SERVICE REQUIRED
. Do this by pressing once on
then once on .