A-Neuvideo ANI-HDROTATE, Инструкция по эксплуатации

Страница: 16 / 24

14
VIDEO WALL CONTROL SOFTWARE
Pre-Defined Video Wall Layouts
The position, size and angle of the display connected to each unit is set in the Layout window when in Rotation Mode. If you are currently
in the Setting window, clicking on the
“Layout”
button in the upper- left
“Common”
section of the window will switch back to the Layout
window and activate Rotation mode.
The outline of the layout window represents the source video (1920x1080 pixels) and each display must be placed within this space,
without exceeding the edges (not including bezel size, if active). Each display contains a number which matches the ID number of the unit
that is connected to it and the size/position of each display (listed to the left) is measured in pixels relative to its size/position within the
layout space. Pre-defined layouts do not include bezel compensation.
Note:
Video wall configuration and warping is not available in Scaler Mode.
This control software provides a number of common, pre-defined,
video wall configurations which can be selected and easily
applied to any connected units. All pre-defined configurations
are designed around video walls containing 4 displays.
1. SELECTING PRE-DEFINED LAYOUTS:
Select any of the
provided pre-defined layouts from the right-hand scroll bar. After
selecting a new layout, you must confirm that you wish to leave
the current layout.
Note:
It is not possible to save changes to the pre-defined
layouts. Switching to a new layout will remove any changes
made to the current layout.
■
AVAILABLE PRE-DEFINED LAYOUTS:
After confirming
the preferred layout, select all of the units involved in the
video wall from the
“Unit”
section at the top of the window
and then click on the
“Set”
button in the bottom-right corner
of the window to upload the new layout configuration to all
selected units. After clicking
“Set”
, the units will take a few
seconds to fully update with the new configuration.
A NEU VIDEO