EGG STATION (ES-600 & ES-1200)
8
P/N 1010883 08/05 Rev. A
OPERATION
Preparing Unit
1. Turn the Rocker Switch (power On/Off) to ON
(Figure 1).
2. Place Egg Ring into Egg Rack (Figure 2).
3. Vertically place the pins of the Egg Rack into the
slots that are attached to the cover.
4. Check to see that all Egg Rings are seated flat on
the Platen surface.
5. Ensure that the Egg Rack and cover are in the
down position while the cooker warms up.
6. Put melted butter (or equivalent) in one Service
Pan (if desired) and slide Service Pan into tray on
right side of unit.
7. Slide second Service Pan into tray for use as
Platen scrapings collector (if desired).
8. Allow the unit to preheat for approximately 20-30
minutes.
NOTE: The Ready Indicator Light will flash while
the unit is heating up and will stay on after the unit
reaches operating temperature.
Cooking Instructions
1. Open the cover. Brush Egg Rings and Platen
Surface beneath the rings with melted butter or
equivalent.
2. Crack eggs on the Egg Cracker and drop each egg
into an Egg Ring (Figure 2).
Figure 1. Operating Controls
Figure 2. Cover Assembly (12 and 6 Egg)
START/STOP
POWER
2'-00"
2'-30"
READY
COOKING
BACON
1
2
3. Break the egg yolks if desired.
4. Close the cover.
5. Fill the trough (Figure 2) on top of the cover with
water, using the plastic dispensing bottle provided.
6. Press one of the Time buttons to select the cooking
time (Figure 3).
7. Press and release the Start/Stop switch (Figure 1)
to start the time cycle.
NOTE: The cooking indicator light will light when
the Start/Stop switch is pressed and released.
Trough
Trough
Cover
Assembly
(12 Egg)
Cover
Assembly
(6 Egg)
Egg
Cracker
Egg
Cracker
Egg Rack
(12 Egg)
Egg Rack
(6 Egg)
Egg Ring
Egg Ring
8. If desired, place sliced meat (Canadian bacon,
ham, etc.) on the front part of the Platen when
“Bacon” indicator light begins to flash and the
audio signal sounds (see
Bacon Timer
in the
Operation section of this manual).
9. At the end of the cycle, when the “Cooking” indi-
cator light turns off, press the “Start/Stop” switch
to turn off the audio signal.
10. Remove the product from the Platen surface.
11. Open the cover and raise the Egg Rack about 1”
(26 mm), then drop the rack to loosen the eggs.
Trough
Egg Rack
(6 Egg)
(4 inch rings)
Egg Ring
Egg
Cracker
Cover
Assembly
(6 Egg) (Mfg.
No. 9300574
only
