4.1.
First check that there is no large quantity of ash in the burning chamber. This would cause hot
particles to fall from the fireplace insert into the room when adding wood.
2.
3.
Place into the upper part of inserted wood
(Fig. 7b)
, between the small pieces of wood,
the stated ignition piece then ignite it.
FiG. 7a
FiG. 7b
Open the door of the fireplace and on the bottom of the chamber place the dose of fuel
recommended for your type of the fireplace insert against the rear wall. First place the
larger pieces of wood, then smaller pieces
(Fig. 7a)
.
COMMISSIONING, BURNING PHASE AND REGULATION OF AIR SUPPLY
4. OPERATION OF FIREPLACE INSERTS
1.
Set the handle for regulation of the air supply for burning to the maximum
This ensure a sufficient supply of air for ignition.
09
4. Close the door and observe the fire until it is fully burning.
5. If the file is burned and the whole dose of fuel is burning, set the regulation of the air
supply into the central position (Fig. 8) to achieve the optimal output .
If the burning did not start, repeat the step No. 4.
If it is not necessary, do not open the door of the fireplace and do not interfere with the burning Leave
the dose of the fuel to burn out. Add the next dose in the heat phase (active burning with flames
terminated). Slowly open the door to prevent the escape of smoke into the room and add the dose of
the fuel to your fireplace .
6.
