Operating and Assembly Instructions – A.B.S. Flexilo MODUL for wood pellets
Assembly
Subject to technical change
Issue 09/2016
Page 24 of 36
©A.B.S. Silo- und Förderanlagen GmbH
Attaching the filling set
5.7 Assembling the cone holding frame
During assembly of different silos an additional cone holding frame must be mounted. The
four cone support bars must be inserted into the loops provided for on the silo sack.
The support bars of the cone holding frame must be screwed together by using the steel
angles provided for.
It is absolutely necessary to guide the screws from the inside to the outside.
holding frame with corner angle
Split Design:
All six bars of the cone holding frame are to be bolted together after they have been inserted
into the intended loops on the silo sack.
The two cone support bars on the long side (the side with the split bars) are to be bolted
together using the connection piece (see pictures below).
You must pull the filler neck in the silo cover over the filling pipe as far as
possible in order to keep the pellets from striking the seam during filling.
