909 PH1000, Инструкция по эксплуатации

Страница: 10 / 16

10
Adding chain oil
WARNING. Never start work unless the chain and bar are
lubricated.
1. Place the chainsaw on its side with the oil cap facing up.
Untwist and remove the oil tank cap (18).
2. Fill the tank to 80% capacity with chain oil.
3. Fasten the cap and wipe up any oil spillage.
Starting and stopping the pruner
1. To start the tool: press the lock button (3) and then press
the trigger (2). Release the lock button once the motor
has started.
2. To stop the trimmer: Release the trigger.
WARNING: Do not connect to power supply until assembly
is complete, Failure to comply could result in accidental
starting and possible serious personal injury.
Changing of the saw chain
ATTENTION: Always pull the power plug before
undertaking any maintenance work.
The saw chain is full of sharp edges. When handling it you
should always wear gloves.
1. Slacken the chain until it
hangs loose by inserting
the included combination
tool into the head screw of
the chain tensioner.
2. Turn the screw counter-
clockwise until the chain is
very loose.
3. Remove the chain bar
cover. Unscrew the hex
nut, and take out the
spring washer. Take off the plastic cover (14).
4. Lift chain and guide
bar off the unit. After
dismounting guide bar
and chain lift the chain off
the guide bar and set the
chain aside.