909 PH1000, Инструкция по эксплуатации

Страница: 8 / 16

8
Assembly
This product has been shipped partially assembled.
1. Carefully remove the items from the box. Make sure that
all items listed in the packing list are include.
2. Inspect the product carefully to make sure no breakage
or damage occurred during shipping
3. Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
Do not operate the tool until any faulty parts have been
replaced or the fault has been rectified. Failure to do so
could result in serious personal injury.
WARNING: Always ensure the secondary handle is fitted to
the shaft whenever you operate this tool.
Assemble the chain and chain bar
1. Remove the chain drive cover screw (17) with the double
ended wrench (13) and remove the chain drive cover.
2. Fully loosen the chain
tensioning screw
3. Place the chain (24) with
the chain links in the
direction shown around
the guide bar.
4. Loop the chain around the
drive sprocket wheel (21).
4. Place the guide bar (10) in position over the threaded
stud with the chain tensioning pin (23), in the hole in the
guide bar.
5. Fit the chain drive cover and fasten the nut, finger tight.
6. Tighten the chain tensioner screw (16) until the links of
the chain just touch the bottom edge of the guide bar.
7 tighten the nut with spanner.