909 PH1000, Инструкция по эксплуатации

Страница: 6 / 16

6
•
Do not stand under the branch you are cutting. Branches
may fall without warning. Work at an angle of no more
than 60°.
• Keep in mind that, when using the upper point of the saw,
the pole saw may kick back quite violently.
• Keep your eyes not only on the branches you are cutting,
also keep an eve on the ground to prevent tripping over
branches that already have fallen.
• Always wear gloves when handling the saw chain.
Danger!
BEWARE OF KICKBACK!
WARNING!
Kickback can lead to dangerous loss of control
of the chainsaw and result in serious or fatal injury to the
saw operator or to anyone standing close by. Always be
alert. Rotational kickback and pinch kickback are major
chainsaw operational dangers and the leading cause of
most accidents.
General notes
The pruner is a rugged, powerful device, but you should
nevertheless note a few words of advice. Always make sure
that there is enough oil in the oil tank.
The chain should always be well-oiled, if necessary soak
the chain in biodegradable chainsaw oil before starting
work. While using the pruner make sure that the chain is
always well-soaked in oil. If this is not the case manually oil
the chain.
Make sure that the oil level does not drop under the
minimum mark. Some light smoking is inevitable and no
reason for concern. Lift off the black plastic cover after every
use and clean the area under it. Also clean the pinhole in
the oil container lid after each use. Keep the groove in the
guide bar clean at all times.
If the unit fails to oil the chain properly it may well be that
the groove is full of saw dust and bark shavings. Remove
the chain and clean out the groove with a suitable tool or
blow it out with compressed air. To keep the unit at top
performance the chain must be sharp.
If you notice that the unit’s performance is not as it should
be and the chain does not eat into the wood by itself, the
chain should be sharpened. Either use the saw chain
sharpener or have the chain sharpened by a professional.
When the chain is ground down to the wear mark it should
be replaced. Saw chains are available in sets of two and
one drive sprocket. The drive sprocket should be changed
after every second chain.
Unpacking
Due to modern mass production techniques, it is unlikely
that your 909 Power Tool is faulty or that a part is missing.
If you find anything wrong, do not operate the tool until the
parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
Contents of carton
The 909 electric chainsaw is supplied with the following
accessories as standard.
• Chain
• Chain bar
• Double ended wrench
• Chain bar cover