Model 675xi Series IP Phone User Guide
—
25
Installation and Setup – 67
57i CT Cordless Handset
Installation and Setup – 6757i CT Cordless Handset
There are two steps involved in setting up the 57i CT cordless handset. The
charging cradle needs to be plugged in and the batteries need to be installed in
the handset.
Charging Cradle
The charging cradle is designed to be placed on a desk or any appropriate flat
surface. To set up the charging cradle:
1.
Plug the modular cord of the power adapter into the jack on the bottom of the
cradle. Route the cord through the retaining tabs of the molded cord slot.
Verify the cradle rests on all four feet and doesn’t wobble.
2.
Plug the other end of the power adapter into a non-switched AC outlet. It is
recommended that the adapter should not be plugged into an electrical
power bar and should be the only item plugged into the AC outlet.
Battery Installation and Charging
The handset is powered by a nickel metal hydride battery pack. To install and
charge the battery:
1.
Place the battery pack in the battery compartment with the connector wires
pointing towards the bottom of the handset
2.
Connect the battery terminal wire to the charging pins within the battery
compartment
3.
Slide the cover of the battery compartment from the bottom of the handset
until it locks into place
4.
Place the handset, face up, in the charging cradle. The handset should easily
slide into the charging cradle. If it does not, check the battery compartment
cover to ensure it is properly closed.
5.
Check the battery icon on the handset screen to confirm that it is blinking and
that the battery is properly charging.
Non-switched
AC Outlet
