F. Factory Reset Option:
To reset all settings to the original, factory preset levels, highlight the Factory Reset
icon and select YES, as shown in Figure 12.
Figure 12 – The Factory Reset OSD menu
G. 3D mode (5DT HMD 800-26 3D Only):
Selecting this icon allows you to switch your 5DT HMD 800-26 3D between 2D and
3D modes.
Please Note
: Before switching to 3D mode, you will want to increase the
refresh rate to a minimum of 85Hz., but 100Hz or higher is preferable. (Please see
section
5.2). Once the HMD is set to 3D mode, the user cannot make changes to the
refresh rate or the resolution settings without first going back into 2D mode.
3D Modes: 3D1 and 3D2
The 5DT HMD 800-26 3D supports two 3D modes. In both modes, full resolution
frame sequential image input is required.
Figure 13 – The 3D Mode Selection OSD menu
Mode 1: DDC Line Protocol
The DDC line protocol is used principally by the nVIDIA Stereo drivers. If nVIDIA
stereo drivers are active and outputting a 3D signal, the headset will automatically
detect the DDC line and stay locked on the signal.
Note:
The DDC Line Protocol is the highest priority 3D function. If this signal is
present, the headset will function correctly in either 3D1 or 3D2 modes.
Mode 2: Frame Sequential Stereo
With frame sequential stereo input the user can select either 3D1 or 3D2 to activate
the frame swapping function. However, if the image on the headset is in reverse
stereo, simply switch to the opposite mode.
12
