16
17
uninstalling the IsofIX system
1. press the unlock buttons on the isoFiX system and, keeping them held
down, pull backwards. The device will open, thereby releasing the seat.
Installing the top tether
1. Take the Top Tether. lengthen the strap if necessary by pressing the
Top Tether brake button
(G)
to release the strap.
2. attach the Top Tether hook to the Top Tether anchorage point which is
recommended in the owner's manual for your car (fig. 3.3).
look for this symbol
in your vehicle.
3. To tighten the Top Tether, remove any slack by pulling on the free
end of the strap until it is suitably tightened. The Top Tether will be
properly tightened when the tension indicator turns completely green
(fig. 3.4).
4. InstallInG the chIld seat. GrouP 1
VehIcle Belt
1. pull the hip Vehicle belt out and guide it through the belt guider group 1
of the child seat. Make sure that the belt is not twisted (fig. 4.1).
2. Engage the buckle tongue in the vehicle seat buckle this should make a
click
noise (fig. 4.2).
3. Then open the belt retaining clip group 1, pull the shoulder vehicle belt
through belt retaining clip group 1 at the same time pull the diagonal
belt strongly to tighten upwards (fig. 4.3).
4. at last closed both belt retaining clip group 1 (fig. 4.4).
5.
cautIon!: When you choose gRoUp 1 vehicle belt insTallaTion hip
belt must through both side belt guider group 1.
3. InstallInG the chIld seat. GrouP 1
toP tether
only for use with Group 1 from
approx. 9 months to 4 years of
age (9-18 kg)
notIfIcatIon
1. pull the fabric loop to pull out both isoFiX connecter until you hear a
click sound which indicates they are fully engaged (fig. 3.1).
2. Fasten the isoFiX adapters to their respective connectors on the car seat,
ensuring that they make a "click" sound when they lock into place. The isoFiX
system indicator will change from red to green, confirming that it has been
properly locked (fig. 3.2).
3. push the child seat against the car seat to check that the isoFiX system
is fully latched, ensuring that the child seat is completely in contact with
the car seat.
2. InstallatIon PoInts WIthIn the VehIcle
facing the direction of travel
on seats with:
isoFiX hooks (between the seat and the seat back) and Top Tether
anchorage points (such as on the rear shelf, on the ground or behind the
seat) and a 3-point seatbelt (car seatbelt)
notIce:
The child seat must only be used in this seat iF it has a lap and
diagonal belt (3 points).
Please, do not install the safety seat in forward seats except for the
following cases:
1. Whenever the vehicle does not count with rear seats. / 2. When all rear
seats are already occupied by children exceeding 135 cm height. /
3. When it
is not possible to install all child restraints systems in the rear seats.
