4tek RAIN2+, Инструкция по установке и эксплуатации

Страница: 22 / 36

22
2. Safety instruction
2.1. Caution: to prevent injury
•
Never operate this product if it has a damaged cord or plug. If it is not working
properly, has been dropped, damaged or has fallen into water, please contact
appropriate service center for examination and repair
•
Keep the cord away from heated surfaces. All electrical products generate heat. To
avoid serious burns, NEVER touch suction motor during or immediately after
operation. The temperature of suction motor can be reach 120
℃
.
•
Never block any air exhaust valve or place it on a soft surface where the openings
may be blocked. The air exhaust valve is for ventilation of the motor inside the
housing. Keep the air exhaust valve free of lints, dirt and other foreign objects
Blocking air exhaust valve can cause the product to overheat and fire
•
Never drop or insert fingers or any other object into any openings
•
Use only in well ventilated areas. The motors on all products are totally enclosed fan
cooled
WARNING
Do not operate the pumps in an atmosphere containing flammable or
explosive gases/vapors
•
Be sure to properly identify intake and discharge before using
•
Protect unit from contaminants and moisture
WARNING
Remove plug from air exhaust port before using
2.2. Caution: to reduce risk of electrical shock
•
Do not disassemble. Disassembly or attempted repairs if accomplished incorrectly
can create electrical shock hazard. Refer servicing to qualified service agencies only
•
Do not use this product in or near area where it can fall or be pulled into water or
other liquids
•
Do not reach for this product if it has fallen into liquid. Unplug immediately
•
Never operate this product outdoors in the rain or in a wet area
2.3. Danger: to reduce risk of explosion or fire
•
Do not use this unit in or near explosive atmospheres or where aerosol (spray)
products are being used
•
Do not use this product near flames
2.4. Description and classification
The equipment is a wet suction used during dental treatment. It consists of an air ring
aspirator, a separator and a control board. When the dentist put the cannulas up, the air ring
suction starts to run so it sucks secretions, water and blood
from the patient’s mouth. They
will go inside of the separator that, being assembled on the same tree of the electrical motor,
will use the centrifugal force to separate water and liquids from air: so water will be