V-Series Camera Quick Start Guide |
VX-2V-MD-RIWH
12000 Pecos St., Suite 290, Westminster, CO 80234 | www.3xlogic.com | (877) 3XLOGIC
13
Purpose
:
If the camera is installed outdoors, you can use the supplied water-proof tape to protect cable connectors and
unused cables after the camera is secured to the installation surface.
Steps:
1.
Tear off the yellow release paper on the back of the water-proof tape.
2.
Stretch the water-proof tape to reach twice the initial length.
Stretch
Stretch
Initial Length
Waterproof Tape Length After Stretching
Stretch the Water-proof Tape
3.
Wrap the water-proof tape around the cable connector tightly as shown in the figure below.
Cable Connector
Wrap the Water-proof Tape
Note:
Make sure that all exposed wires are all firmly wrapped and concealed by the water-proof tape.
4.
Press the tape firmly on both ends of the connector to make sure no water can penetrate, as shown in the
figure below.
Press
Pre
ss
Press
Pr
es
s
Press the Water-proof Tape
5.
Wrap the water-proof tape around the remaining unused cables tightly as shown in the figure below (some
camera models may not feature all the pictured cables).