3xLogic VX-2V-MD-RIWH, Быстрый старт, Страница: 12 / 20

V-Series Camera Quick Start Guide | VX-2V-MD-RIWH
12000 Pecos St., Suite 290, Westminster, CO 80234 | www.3xlogic.com | (877) 3XLOGIC 12
(OPTIONAL) INSTALLATION OF NETWORK CABLE WATER-PROOF JACKET
Purpose:
If the camera is installed outdoors, you can install a waterproofing jacket for the network cable after the
camera is secured to the installation surface.
① ② ③ ④
⑤
⑥ ⑦
Water-proof Accessory Components
Table 1-2 Components
No. Components
1
Camera’s Network Interface
Socket
2 O-Type Gasket
3 Network Plug
4 Waterproof Endcap
5 Waterproof Rubber Gasket
6 Lock Nut
7
Network Cable from
Router/Switch
Steps:
1. Feed the plugless network cable ⑦ through the lock nut ⑥ , waterproof rubber gasket ⑤ (the rubber
gasket inset ridge must face the waterproof endcap), and the waterproof endcap ④ in order.
2. Crimp an RJ-45 network plug ③ onto the end of the cable, taking care to insert the twisted pairs of wires in
correct order.
3. Place the O-type gasket ② onto the end of the camera’s network interface socket ① .
4. Insert the network plug ③ into the camera’s network interface socket ① .
5. Insert the waterproof rubber gasket ⑤ into the waterproof endcap ④ , and secure lock nut ⑥ with the
waterproof endcap ④ .
6. Align the snap on the waterproof endcap ④ with the notch on the camera’s network interface socket ①,
and then secure the waterproof endcap ④ to the camera’s network interface socket ① to finish installation.
Camera
Switch/Router
Align the snap and notch.
i. Insert
⑤
into
④
.
ii. Secure
⑥
with
④
.
Water-proof Accessory Installation
(OPTIONAL) INSTALLATION OF WATERPROOF TAPE