Hardware and Installation Manual
|
VISIX V-Series All-in-One Cameras
–
Gen I
12000 Pecos Street, Suite 290, Westminster, CO 80234 | www.3xlogic.com | (877) 3XLOGIC
5
CAUTIONS:
Make sure the power supply voltage is correct before using the camera.
Do not drop the camera or subject it to physical shock.
Do not touch sensor modules with fingers. If cleaning is necessary, use a clean cloth with a
bit of ethanol and wipe it gently. If the camera will not be used for an extended period of
time, put on the lens cap to protect the sensor from dirt.
Do not aim the camera lens at the strong light such as sun or incandescent lamp. The
strong light can cause fatal damage to the camera.
The sensor may be burned out by a laser beam, so when any laser equipment is being
used, make sure that the surface of the sensor not be exposed to the laser beam.
Do not place the camera in extremely hot, cold temperatures (the operating temperature
should be between -30°C ~ 60°C, or -
40°C ~ 60°C if the camera model has an “H” in its
suffix), dusty or damp environment, and do not expose it to high electromagnetic
radiation.
To avoid heat accumulation, good ventilation is required for a proper operating
environment.
Keep the camera away from water and any liquid.
While shipping, the camera should be packed in its original packing.
Improper use or replacement of the battery may result in hazard of explosion. Please use
the manufacturer recommended battery type.
NOTE:
For cameras that support IR, you are required to pay attention to the following precautions to
prevent IR reflection.
►
Dust or grease on the dome cover will cause IR reflection. Please do not remove the
dome cover film until the installation is finished. If there is dust or grease on the dome
cover, clean the dome cover with clean soft cloth and isopropyl alcohol. (only applies
to certain models).
►
Make certain the installation location does not have reflective surfaces of objects too
close to the camera. The IR light from the camera may reflect back into the lens
causing reflection. (only applies to certain models).
►
The foam ring around the lens must be seated flush against the inner surface of the
bubble to isolate the lens from the IR LEDS. Fasten the dome cover to camera body so
that the foam ring and the dome cover are attached seamlessly (only applies to certain
models).
