Hardware and Installation Manual
|
VISIX V-Series All-in-One Cameras
–
Gen I
12000 Pecos Street, Suite 290, Westminster, CO 80234 | www.3xlogic.com | (877) 3XLOGIC
14
2.4.2
ADJUSTING ANGLE OF THE CAMERA
Adjust the camera to the desired angle by unscrewing the joints referring to the following pictures.
Steps:
1).
Insert the video output cable (included in the
package) to the video output cable socket, and
connect it to an analogue video test monitor to
check if the camera angle has been set as
intended. If the angle is appropriate, disconnect
the camera from the analogue monitor, and then
remove the video output cable from the camera.
2.4.3
ADJUSTING ZOOM AND FOCUS (VX-2A-B-
IWD MODEL ONLY)
Steps:
1).
Unscrew the zoom puller and the focus puller
counter-clockwise.
2).
Adjust the zoom and the focus of the lens.
3).
Tighten the zoom puller and the focus puller again by
turning it clockwise after the zoom and the focus are
properly adjusted.
CAUTION:
Manual adjustment of Zoom and Focus is only
possible on the VX-2VA-B-IWD model version. Zoom and Focus controls can be configured digitally from
the camera’s web interface for VX
-2VA-B-RIWD models. See the VISIX V-Series All-in-One Camera User
Manual for more details on adjusting lens settings from the camera’s web interface
.
Adjust the joint to install
the camera on the wall.
Tilting adjustment
Panning adjustment
Zoom Puller
Focus Puller
Video Out
Reset
PAL/NTSC
SD Card
Video output
cable
socket
