15
Note:
1.
Label paper of
4"
wide is required to print all the debugging mode data.
2.
Restart the printer to leave the debugging mode and return to the normal printing mode,
or press the
FEED
button to return to the standby state.
4.3.3
Printer initialization
The printer initialization function is to clear the downloaded files in the memory (DRAM) and
restore the print parameters to the factory default settings.
Please follow the steps below to complete the initialization:
1.
Turn off the power.
2.
Hold down the feed button and turn on the power. At this point, the power indicator color
will cycle as follows:
◼
Indicator color cycle mode:
Purple
→
Blue
→
Red (blink 5 times)
→
Purple (blink 5 times)
→
Blue (blink 5 times)
→
Blue (fixed)
3.
Release the feed button when the power indicator is blinking blue. At this point, the printer
will be reset, and then the power indicator will blink purple once, and finally the power
indicator will be blue in ready state.
After initialization, the printer configuration is restored to its default values as follows:
Parameters
Defaults
Speed
152.0 mm/sec (6 ips) (203DPI)
Density
8
Label width
4” (100 mm)
Label height
7.9” (180 mm)
Sensor type
Gap sensor
Gap setting
0.16” (4.0 mm)
Printing direction
0
Reference point
0,0 (upper left corner)
Offset
0
Tear-off mode
On
Peel-off mode
Off
Characters
850
Country code
001
Clear flash
No
IP address
DHCP
