3M SST, Руководство пользователя

Страница: 59 / 90

SST Transport and Burster Mechanism Manual 75-0302-1450-8, Version 1 Ch. 5 Testing the SST Transport Unit • 49
Note: If you do not see “READY”, make sure that the Omega SST Controller and the CPU
Board are receiving power. Also make sure the coiled phone cord that connects the SST
Omega and the CPU Board are connected properly. If “NOT IN OPERATION” continues
to be displayed, exchange the Omega SST Controller and/or CPU Board with known good
units until you can diagnose the problem.
2. Close DIP switch 7 on Switch Bank 4 on the SST Terminal Board. “INSERT TICKET”
should appear on the LCD display.
3. Insert a paid ticket, generated by a fee computer or an Automatic Pay Station. If the SST
Exit Verifier reads the ticket, the message “THANK YOU” will be displayed on the SST
Exit Verifier LCD display.
Note: If “UNREADABLE TICKET” is displayed, there is a read problem with the CPU Board
or SST.
4. Open DIP switch 7 on Switch Bank 4 on the SST Terminal Board.
Testing the Burster in the MG-1000 SST Ticket Spitter
Once you place the Burster in the MG-1000 SST Ticket Spitter, you should test it to make sure that
it is functioning within specifications. Use this procedure with both the Single Infeed and Dual
Infeed Bursters. To test the Burster, complete the following steps:
5. Turn power switch ON.
6. Load tickets in the Burster. If you have a Dual Infeed Burster the tickets should kick-back.