Step 3: Connect water supply to the SGLP-RO System
Step 4: Remove SW-IX-60 cartridge and install filter plug
included with the RO system (For SW4-PLUS ONLY)
NOTE: If possible, the water supply should be tee’d off of the existing filter system. Refer
to installation diagrams below.
For SW3-PLUS and SW260-PLUS, follow these steps.
1) Close the water inlet valve on the existing beverage and ice filter system.
2) Run ¼” tubing from the filter system outlet to the SGLP-RO using the appropriate fittings
and tubing (not included).
For SW4-PLUS, follow these steps.
1) Close the water inlet valve on the existing beverage and ice filter system.
2) Run ¼” tubing from the filter system outlet to the SGLP-RO using the appropriate fittings
and tubing (not included).
Tee Fitting
(Not Included)
To SGLP-RO
Inlet - 3/8"
Flare Fitting
To Post Mix
Dispenser
To SGLP-RO Inlet
NOTE: This step is for the SW4-PLUS system only. If a SW3-PLUS or SW260-PLUS
system is installed, skip to next step.
1) Remove the SW-IX-60 cartridge by rotating cartridge to the right and pulling down on it.
2) Dispose of cartridge in accordance with federal, state, and local regulations
3) Insert filter plug that was included with the SGLP-RO Reverse Osmosis System by
inserting plug in filter head and turning to the right until plug hits stop. You should hear a
click when the plug is fully inserted.
5
