3M SCOTT PAK-ALERT, Инструкция по эксплуатации и обслуживанию, Страница: 4 / 24

Page 4 of 24
P/N 595370-01 Rev B 07/19
WARNING
READ AND UNDERSTAND THIS ENTIRE MANUAL
AND THE PAK-TRACKER LOCATOR SYSTEM
MANUAL. TRAINING IS REQUIRED BEFORE
USE OF THIS EQUIPMENT IN A HAZARDOUS
SITUATION. THE TRAINING MUST INCLUDE
AN UNDERSTANDING OF THE LIMITATIONS
OF THE EQUIPMENT AND HOW TO INTERPRET
LOCATING INFORMATION, ALONG WITH
EXTENSIVE PRACTICE WITH THE SYSTEM
IN A VARIETY OF ENVIRONMENTS. USE
OF THIS EQUIPMENT MUST BE PART OF A
COMPLETE PERSONNEL ACCOUNTABILITY
SYSTEM. ALWAYS UPDATE TRAINING WITH
EACH NEW PIECE OF EQUIPMENT. USE OF A
PAK-TRACKER LOCATOR SYSTEM WITHOUT
PROPER TRAINING MAY PLACE THE USERS
AT HIGHER RISK IN DANGEROUS SITUATIONS,
WHICH COULD RESULT IN SERIOUS INJURY
OR DEATH.
The Locator System is a two-part electronic system consisting of a
transmitter integrated into the distress alarm, and a Hand Held Receiver
(HHR), which is a directional receiver used to locate the signal coming
from the transmitter. The transmitter is activated by the distress alarm. The
transmitter emits a radio signal with a unique ID number that can be tracked
using the HHR.
TRAINING AND PRACTICE IN REALISTIC EMERGENCY SIMULATIONS
IS REQUIRED BEFORE USE OF THIS EQUIPMENT. Users must become
thoroughly familiar with the operation and the limitations of the Locator
System before entering a potentially hazardous or life threatening situation.
The 3M Scott Pak-Tracker Locator System user instructions (P/N 595278-
01) contain essential information on the use of the Locator System and must
be used as the basis of training for use of the whole system including use
with a distress alarm equipped with the 3M Scott Pak-Tracker transmitter.
The Locator System user instructions include an overview of the system
operation, limitations of the system, as well as any user-level maintenance
for the Locator System equipment. Copies of the user instructions are
available from the company or your distributor.
The HHR serves as a directional
receiver to assist in leading the
rescue team to the activated
transmitter. By pointing the HHR in
the direction of the strongest relative
signal, the rescue crew can follow
the signal toward the SCBA user
who is incapacitated or in need of
assistance.
Use of the Locator System must
be part of a complete personnel
accountability system that includes
procedures for monitoring the
deployment and condition of all
users. Do not rely on the Locator
System as the only technique for
locating missing personnel. Failure
to use this equipment properly may
actually increase the time needed
to locate and rescue personnel.
FIGURE 3
PAK-TRACKER
HAND HELD RECEIVER (HHR)
DATA LOGGING FEATURE
SCBAs equipped with the SEMS II Pro Wireless SCBA Telemetry System
are compliant with NFPA 1982, 2018 Edition. The distress alarm includes
on-board electronics which maintain a running log of event data including
start-up, shut-down, and PASS activation. The Scott Connect Configure
software and the 3M Scott Pak-Link Programmer (P/N 200672-01) are
required to access the information. Instructions for downloading the data
log are included in the Scott Connect Configure Instruction Guide, which is
available within the Scott Connect Configure software application.
Downloading data from the SCBA will also do the following:
• Overwrite the programmed RFID card number; the PAK ID returns to
the default ID number.
• Reset the SCBAs internal clock to match the time settings on your PC.
NOTE
UPON RECEIVING 3M SCOTT AIR-PAK SCBA'S, UPDATE THE
ELECTRONICS TO THE LOCAL TIME ZONE USING SCOTT
CONNECT CONFIGURE SOFTWARE AND THE 3M SCOTT PAK-LINK
PROGRAMMER (P/N 200673-01).