2
2.2. CAUTION
• Risk of explosion if battery is replaced by an incorrect type.
•
Always use product-specific 3M replacement parts. Use of
unauthorized replacement parts may reduce the protection
you receive from this product.
• Only use AA or AAA non-rechargeable (as applicable) or
3M™ PELTOR™ Ni-MH rechargeable LR6NM or LR03NM
(as applicable) batteries. These rechargeable batteries
might not be available in all markets.
2.3. NOTE
• When worn according to these User Instructions, this
hearing protector helps reduce exposure to both continuous
noises, such as industrial noises and noises from vehicles
and aircraft, as well as impulse noises, such as gunfire. It is
difficult to predict the required and/or actual hearing
protection obtained during exposure to impulse noises. For
gunfire, the weapon type, number of rounds fired, proper
selection, fit and use of hearing protection, proper care of
hearing protection, and other variables will impact
performance. To learn more about hearing protection for
impulse noise, visit www.3M.com.
• This hearing protector is provided with level-dependent
attenuation. The user should check correct operation before
use. If distortion or failure is detected, the user should refer
to the manufacturer’s advice for maintenance and
replacement of the battery.
• This hearing protector is provided with safety-related audio
input. The user should check correct operation before use.
If distortion or failure is detected, the user should refer to the
manufacturer’s advice for maintenance.
• This hearing protector limits the entertainment audio signal
to 82 dB(A) effective to the ear.
• In Canada, users of carriers combined with earmuffs must
refer to CSA Standard Z94.1 on industrial protective
headwear.
• Operating temperature range: –20°C (–4°F) to 50°C (122°F)
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable batteries.
• To properly dispose of the battery, follow local solid waste
disposal regulations.
• Attention – Product imagery is for illustration only.
2.4. U.S. EPA REQUIRED STATEMENTS
Improper fit of this device will reduce its effectiveness in
attenuating noise. Consult the enclosed instructions for
proper fit.
Although hearing protectors can be recommended for
protection against the harmful effects of impulsive noise, the
Noise Reduction Rating (NRR) is based on the attenuation of
continuous noise and may not be an accurate indicator of the
protection attainable against impulsive noise such as gunfire
(wording required by EPA).
The level of noise entering a person’s ear, when hearing
protector is worn as directed, is closely approximated by the
difference between the A-weighted environmental noise level
and the NRR.
Example:
1. The environmental noise level as measured at the ear is
92 dB(A).
2. The NRR is 23 decibels (dB).
3. The level of noise entering the ear is approximately equal
to 69 dB(A).
CAUTION:
For noise environments dominated by frequencies
below 500 Hz the C-weighted environmental noise level
should be used.
3. APPROVALS
All of the approvals referred to in this section might not apply
to your specific model. If an approval doesn’t apply to your
model, this can be seen on the label(s) on the product.
3.1. EUROPEAN APPROVALS
EU
Hereby, 3M Svenska AB declares that the Bluetooth is in
compliance with Directive 2014/53/EU and other appropriate
directives to fulfill the requirements for the CE marking.
3M Svenska AB also declares that the PPE type hearing
protector is in compliance with Regulation (EU) 2016/425.
The PPE is audited annually by SGS Fimko Ltd., Takomotie 8,
FI-00380 Helsinki, Finland, Notified Body No. 0598, and type
approved by PZT GmbH, Notified Body No. 1974,
Bismarckstrasse 264 B, 26389 Wilhelmshaven, Germany.
The product has been tested and approved in accordance
with EN 352-1:2020, EN 352-3:2020, EN 352-4:2020,
EN 352-6:2020 and EN 352-8:2020.
GB
Hereby, 3M Svenska AB declares that the Bluetooth and radio
communication is in compliance with Radio Equipment
Regulations 2017 and other appropriate Regulations to fulfill
the requirements for the UKCA marking.
3M Svenska AB also declares that the PPE type hearing
protector is in compliance with Personal Protective Equipment
Regulations (Regulation 2016/425 as brought into UK law
and amended).
The PPE is audited annually, and type approved by SGS
United Kingdom Limited, Rossmore Business Park, Ellesmere
Port, Cheshire CH65 3EN, UK, Approved Body No. 0120.
The product has been tested and approved in accordance
with EN 352-1:2020, EN 352-3:2020, EN 352-4:2020,
EN 352-6:2020 and EN 352-8:2020.
0120
EU and GB
The applicable legislation can be determined by reviewing the
Declaration of Conformity (DoC) at www.3M.com/peltor/doc.
The DoC will show if some other type-approvals are also
applicable. When retrieving your DoC, please locate your part
number. The part number of your earmuffs can be found at
the bottom of one cup.
EN