3M Dynatel 1420-iD, Руководство оператора

Страница: 10 / 28

10 78-8130-6741-6 Rev G
Step 11. The prompt line will display: Download Completed Successfully , when
finished. The marker types legally allowed in the country selected in Step 6
above will be activated at this time.
Step 12. Multiple units may be configured at this point by simply connecting the next
locator, powering it on, and clicking
Download
.
Step 13. Click Exit when all locators have been updated.
C. Enabling/Disabling 3M™ Marker and Path Frequencies
Menu [6] + >>More [SK:4] + Setup [SK:6] + >>More [SK:6d] + Marker Type [SK:6f]
Note: 3M Dynatel
™
Electronic Marking System (EMS) Locator U-Model will default
with all marker types enabled (
✓
)
Step 1. Press the up/down arrows [SK] to highlight
a utility to enable or disable.
Step 2. Press Enabl/Disabl [SK].
− Only the markers that are enabled (

)
will be available in the locate mode.
Step 3. Press Locate/OK [5] to save settings or Exit
[SK] to cancel.
D. Single Marker or Path Locate
Step 1. Press
Locate/OK
[5].
Step 2. Press
Marker
[SK].
Step 3. Press Markr 1 [SK Toggle] to select
desired utility.
Step 4. Markr 2 should be OFF.
Note: Only the marker types enabled in the setup
menu will be shown. (See 4.C. Enabling/Disabling
Marker types). When scanning for markers, the
Gain Level [12] should be set high.
− When a marker is detected, adjust the
Gain [4] down until the bar graph opens.
− The bar graph will close, the audio will
be steady, and the Signal Strength [10]
will be maximum when the locator
detects a marker of the specified utility
and has pinpointed its location..