3M 963, Инструкция по эксплуатации

Страница: 5 / 11

6
4.2 Determine the location of an
appropriate electrical outlet. For
the 963, connect the power cord to
the ionizer, and insert the other end
of power cable into the appropriate
electrical outlet. For the 963E,
connect the universal power supply
to the ionizer, using the Mini DIN
connector. Then, using the
appropriate electrical power cord,
connect the universal power supply
to an electrical outlet.
Section 5.
Operation
The three position rocker switch on the
front of the unit is the POWER switch.
The center switch position (marked
O
)
is the OFF position. The upper and
lower switch positions (marked
II
and
I
) turn the unit on to HIGH and
LOW fan speeds. Use this switch to
turn the unit on and to select the desired
fan speed. A green monitor light is
also illuminated on the front of the
unit, which indicates that the power
switch is in one of the ON positions,
and that the ionizer is now in use.
Section 6.
Maintenance
Occasional cleaning of the case and of
the emitter points are the only routine
maintenance procedures required.
6.1 Cleaning the case: wipe the case
with a soft cloth moistened with
water. If a stronger cleaning
solution is required, mild
detergent or alcohol may be used.
Do not use solvents that will
attack the plastic case.
6.2 Cleaning the emitter points: when
the emitter points become dirty,
the internal circuitry of the ionizer
will be automatically adjusted to
emit an equal amount of positive
and negative ions. Contamination
on the needlepoint, however, may
inhibit ionization to a limited
degree. The emitter points are
located between the fan blades
and the rear grill. A jet of clean,
compressed air can be used to
remove dirt on emitter points. If a
more rigorous cleaning method is
needed to remove particulate,
clean the points with a cotton
swab. Access to the points is
available through the rear grill.
Be careful not to damage the
points during cleaning.