3M 3M-Matic a80b, Инструкция и перечень запасных частей

Страница: 28 / 58

18
7-INSTALLATION
(continued)
2011 April
a80b-NA
7.5 Removal of Plastic Ties
Cut any existing plastic ties (where applicable -
Figure 7-4).
Figure 7-6 Figure 7-5
•
To reduce the risk associated with
sharp blade hazards:

Keep hands and fi ngers away from tape
cutoff blades under orange blade guards.
The blades are extremely sharp.
WARNING
7.6 Assembly Completion
1. Cut the plastic ties holding the lower
taping head in position. Hold taping head buff-
ing roller while cutting the plastic tie. Allow buff-
ing/applying arms to extend slowly
(Figure 7-5).
2. Verify that the taping heads moves freely by
pushing the buf fi ng roller into the taping head.
3. Ensure that the tape drum bracket assembly
(located on the taping head) is mounted
vertically (as shown in
Figure 7-6
).
Note:
The tape drum bracket assembly may be
pivoted to provide tape roll clearance if
necessary.
7.7 Completion of Taping Heads
See Manual 2 for Complete Instructions:
Important –
Do not cut against the apply roller -
roller damage could occur.