3M 3M-Matic 800rf, Инструкция и перечень запасных частей

Страница: 41 / 122

10-SAFETY DEVICES OF THE MACHINE
Rear E-Stop
29
10.1 Blade and Safety Guards
Both the top and bottom taping units have a blade
guard
(See Manual 2: AccuGlide™ 3 Taping
Heads - 2 Inch).
10.2 Emergency Stop Button
The box drive belts are turned on and off with the
electrical switch on the side of the machine frame.
The machine electrical supply can be turned off
by pressing the latching emergency stop switch.
To restart machine, rotate the emergency stop
switch clockwise to release the switch latch.
Restart machine by turning the On/Off switch to
the Off (O) position and then to the On (I) position
(Figure 10-1).
10.4 Electric System
The electric system is protected by a ground wire
whose continuity has been tested during the
fi nal
inspection. The system is also subject to insulation
and dielectric strength tests.
10.3 Stop Switches
The
Model 800rf Type 40800
Case Sealer is equipped
with three STOP switches. Their locations are shown
in
Figure 10-2.
Pressing either of the red E-Stop
switches stops the machine, removing electrical power
and air pressure from the case sealer. To restart the
machine, you must turn and release the E-Stop switch
and then press the RESET button and the START (I)
button on the Electrical Control Panel.
Pressing the STOP (O) button on the Electrical Control
Panel stops the machine and does not remove power
from the controller. To restart the machine, you must
press the RESET button and then the START (I) button.
2012 March
800rf-NA
•
To reduce the risk associated with
mechanical and electrical hazards:
− Allow only properly trained and quali fi ed
personnel to operate and service this
equipment.
WARNING
Note:
The case sealer has a circuit breaker
located in the electrical enclosure on the machine
frame. If circuit becomes overloaded and circuit
breaker trips, unplug the machine electrical
cord and determine cause of overload. After two
minutes, reset the circuit breaker. Plug machine
electrical cord into outlet and restart machine by
pushing the On/Off switch to the On (I) position.
Important:
The use of an extension cord is not
recommended.
•
To reduce the risk associated with
sharp blade hazards:
− Keep hands and fi ngers away from tape
cutoff blades under orange blade guards.
The blades are extremely sharp.
WARNING
WARNING
Figure 10-2
Safety Guard
It limits the access to the machine, protecting the
operator from the moving parts
(Figure 10-1).
•
To reduce the risk associated with
hazardous voltage:
− Position electrical cord away from foot
and vehicle traf fi c.
E-Stop
3308mm
2050mm
1830mm
Stop
Power
Start
Figure 10-1